Catherine Carpet June 19th, 2018 - 19:49:05
Use an awl to lift the edge of the carpet. Go to a corner of the room and poke the awl right through the carpet about 6" from the wall. From here you will be able to pull the carpet up. If you dont have an awl you can probably use a pair of pliers. Now its time to unpack the carpet stretcher. Set it up so that the foot end is up against the baseboard and the head is a few inches from the wall that you are stretching towards. The power stretcher is more than strong enough to rip carpet so be careful to only stretch the carpet just enough to remove the wrinkles (and maybe just a little bit more). Over stretching carpet isnt a good idea because you will create ripples going the other direction. So again only stretch the carpet as much as you need to in order to remover the ripples.
Removing replacing or installing new built-in furniture walls floor heaters toilets cabinets and other fixtures are just a few reasons that a carpet installer will need install the carpet properly into the room. This will require some new tack strip and possibly some new carpet and pad to add to the area. Many times the customer will have some carpet left over from the installation. If not we can often take carpet from the closet. Removing carpet and carpet pad is simple but sometimes strenuous. If we are trying to save the carpet to use in a different room or to re-carpet the hallway or stairway we will want to try to keep it in one piece. If the objective is just to remove old carpet and old carpet pad we will make it easy on ourselves by cutting the carpet into strips approximately two feet wide.
In spite of these advancements carpet for a household can represent a significant investment. If you are planning to stay in your home for years to come having carpet installed that will be durable and stand up to years of use in an important consideration. To achieve that there are some steps to take that will ensure you get the best value for your investment. Here are some factors to consider. Padding: Keeping carpet looking its best for many years begins even before you look at the first carpet sample. It all begins with the carpet padding. When it comes to carpet padding it may be tempting to go with the least expensive option since its one of those "out-of-sight out-of-mind" materials.
Most carpet cleaners on the market today require a two step process to the cleaning action. Since the solution sprayers are located behind the agitating brush and the extraction head the solution needs to be laid down first in a forward sweeping motion. Pushing down slightly and squeezing the dispensing lever dispense the solution along the desired path you wish to clean. Then following the same path in the return stroke release the solution dispensing lever and pull the machine back to the point to where you first started the stroke. The extraction head is in front of the agitator so on the return stroke the fibers in the carpet are being scrubbed then the excess water is being sucked up by the extraction head.