Catherine Carpet June 18th, 2018 - 19:59:31
If there is just one Berber carpet row that has been pulled it can be re-burled (glued back into place). If the Berber carpet run is more serious say for example a dog was trapped in a room and tried to dig her way out then a patch is in order. If your Berber carpet is loose then it will need to be stretched. Stretching Berber carpet isnt really any different than stretching carpet of any other type. If a carpet comes apart at the seam it can be repaired in several different ways. One way is to glue it back together another way would be to remove the old seam tape and do the entire seam over. If the seam that came apart is on a Berber carpet then it becomes a bit more challenging.
Adding carpet remnants to your living room can be perfect for preventing your existing carpet from getting damaged. A carpet remnant is considered to be any remaining strip of carpet that is left-over from your carpet-installation process; remnants will vary in size and shape. They are typically cut down to a specific size in order to help fill in a carpet space that is damaged or that is getting replaced. When buying a brand new carpet for your home chances are good that you saved all of the extra carpeting that was not used. You may have sold it but most people choose to save their excess carpeting due to the fact that they know that they may need places of their existing carpet to get replaced.
This process was accomplished with a profusion of soap or detergent and water. When the operator thought that the carpet reached maximum cleanliness the carpet would be very thoroughly flushed with water and then suspended on a rail in the air to dry. Another weighted rail would be on the lower end of the carpet to stretch it back to its original dimensions. When the carpet was completely dry the back was resized to replace the sizing lost in the scrubbing procedure. After this step the carpet all clean and beautiful once again was returned to the owner. It was good for another few years of traffic. Although this cleaning method is still employed today it is probably used to a lesser degree since wall-to-wall carpeting has become popular. Wall-to-wall carpeting cannot be removed to provide it with a thorough scrubbing. Therefore one must resort to a variety of alternative methods to achieve this same end. Basically this consists of three steps: a thorough vacuuming spot cleaning of the surface to be scrubbed and the scrubbing-cleaning operation. The cleaning operation may be performed in a variety of ways generally divided into two classifications: surface cleaning and deep cleaning.
Removing the damaged carpet: Start by using a straight edge and a row finder. An ice pick or a Phillips screwdriver can be used instead of a row finder. Place the straight edge on the carpet with the groove side down. Use the row finder to separate the nap. Do this by dragging the point of the row finder across the carpet up and down and against the edge of the straight edge. Use a slotted blade knife with a fresh blade. You can use a slotted blade knife (butted up against the straight edge to cut through the carpet without cutting through too much of the nap if you used the row finder properly. The more nap you cut off the worse the carpet patch will look.