adelaide caouette Carpet June 18th, 2018 - 19:35:34
Like any type of carpet repair stretching carpet is more involved than it seems to be. Stretching carpet isnt just a matter of smoothing out ripples and re-securing or pulling at the edges by hand as you would a bed sheet. Carpet stretching comes with its own tools and techniques that help you do the job right. A professional who repairs carpet for a living will have all of these tools on hand. If you decide to try and stretch carpet yourself most or all of these tools should be available for rental or purchase at a relatively reasonable price. Even contracting out your carpet stretching is far more cost-effective than replacing the carpet so either way these tools in your hands or someone elses save you quite a bit of money.
Removing the damaged carpet: Start by using a straight edge and a row finder. An ice pick or a Phillips screwdriver can be used instead of a row finder. Place the straight edge on the carpet with the groove side down. Use the row finder to separate the nap. Do this by dragging the point of the row finder across the carpet up and down and against the edge of the straight edge. Use a slotted blade knife with a fresh blade. You can use a slotted blade knife (butted up against the straight edge to cut through the carpet without cutting through too much of the nap if you used the row finder properly. The more nap you cut off the worse the carpet patch will look.
Getting a good quality carpet steam cleaner is essential to the cleaning process. Make sure you have one that is of good construction. It is very frustrating to keep fixing a machine that keeps breaking down throughout the process of trying to get the carpets clean. A good carpet steam cleaner should also provide enough suction to pick up most of the water put down in the process. Your carpeting should be damp not wet when the entire cleaning process is done. If your carpets are wet it will take a very long time to dry and it is also an indicator that the carpeting is not as clean as it could probably be. The last thing to look at is the scrubbing action. Most new models of a carpet steam cleaner either use a rotating roller scrub brush or spinning scrubbers. I believe either is good but I prefer the spinning brushes because they seem a little easier to remove for cleaning. If you have pets that shed you will probably be cleaning them several times throughout the project.
Removing replacing or installing new built-in furniture walls floor heaters toilets cabinets and other fixtures are just a few reasons that a carpet installer will need install the carpet properly into the room. This will require some new tack strip and possibly some new carpet and pad to add to the area. Many times the customer will have some carpet left over from the installation. If not we can often take carpet from the closet. Removing carpet and carpet pad is simple but sometimes strenuous. If we are trying to save the carpet to use in a different room or to re-carpet the hallway or stairway we will want to try to keep it in one piece. If the objective is just to remove old carpet and old carpet pad we will make it easy on ourselves by cutting the carpet into strips approximately two feet wide.