Fayme Chandonnet Carpet June 18th, 2018 - 19:18:05
Most carpet cleaners on the market today require a two step process to the cleaning action. Since the solution sprayers are located behind the agitating brush and the extraction head the solution needs to be laid down first in a forward sweeping motion. Pushing down slightly and squeezing the dispensing lever dispense the solution along the desired path you wish to clean. Then following the same path in the return stroke release the solution dispensing lever and pull the machine back to the point to where you first started the stroke. The extraction head is in front of the agitator so on the return stroke the fibers in the carpet are being scrubbed then the excess water is being sucked up by the extraction head.
Turn the carpet patch over and use the straight edge to cut a perfect patch from the back. If you are untrained chances are that you wont be able to cut a perfect patch. (Tip use a fresh blade in the slotted blade carpet knife) Now that the carpet patch is cut exactly perfect without any gaps or overlaps at the seams its time to seal the edges. You can seal the edges with latex or with a glue gun. Just use the slightest amount of glue along both edges so that there wont be fraying in the future. Not everyone seals the edges but it is highly recommended. The carpet patch is cut to perfection the edges are sealed and now youre ready to adhere the carpet patch to the rest of the carpet. The way we do it is to use a special carpet seam tape with an iron or with a hot glue gun. For the beginner Id recommend using the glue gun.
Many people install their own tile but dont know how to finish the job with the carpet to tile transition. Often professional tile installers dont know how to finish their job with a proper carpet to tile transition. There are several good ways to do a carpet to floor transition that I will explain in the carpet to tile transition article. When people refer to a Berber carpet theyre referring to a looped carpet with rows. Its not really a Berber carpet but for our purposes here its okay to call it Berber. For an interesting read on the history of Berber carpet click here. Berber carpet repair is often needed due to a snag in a Berber carpet or a pull in a Berber carpet. A pull in a Berber carpet happens when one or more threads get caught either in a vacuum or some other way. Often times its the family pet or a child that pulls Berber carpet and creates the snag or run.
Removing the damaged carpet: Start by using a straight edge and a row finder. An ice pick or a Phillips screwdriver can be used instead of a row finder. Place the straight edge on the carpet with the groove side down. Use the row finder to separate the nap. Do this by dragging the point of the row finder across the carpet up and down and against the edge of the straight edge. Use a slotted blade knife with a fresh blade. You can use a slotted blade knife (butted up against the straight edge to cut through the carpet without cutting through too much of the nap if you used the row finder properly. The more nap you cut off the worse the carpet patch will look.