Martine Deblois Carpet June 29th, 2018 - 09:47:46
There are basically different phases that need to be completed when cleaning a carpet. Of course this is a very delicate thing in your household which needs to be cleaned properly. Without following these phases you are just risking the worsening of the condition of your carpets so you should always keep these in mind and you are on your way in maintaining the best conditions for your precious carpet. The first phase of carpet cleaning involves the pretreatment of your carpet. This may seem to be an unnecessary carpet cleaning step but in reality this is the most important cleaning step. This prepares and conditions your carpet so that it will be cleaned easily. What is done in this step is that the carpet is spayed or sprinkled with a particular solution that help in cleaning of the carpet. It basically lets the solid particles soils dirt and dust which are trapped inside the carpets to resurface and lift up. This will now make it easier for the particles to be cleaned.
A patch is one of the most common types of repairs that we do. We use a carpet patch to solve several types of carpet problems where small to mid-sized portions of wall-to-wall carpet have been damaged. People usually call us to patch their carpet when other methods to restore their carpet wont work. Common causes of carpet damage that require this type of carpet repair include carpet burns carpet stains carpet tears carpet holes pet damage (Bad Kitty!) and remodeling as well as worn traffic paths. We remove the damaged area and replace it with an identical piece of carpet. When done correctly its normally but not always invisible to the eye. Depending on the type of carpet you may be able to see the patch but it will almost always look far better than what we started with.
Cut the seam tape to the size of the carpet patch. Line up the carpet seam tape so that half of it is under the existing carpet and the other half of it will be under the patch. Use the glue gun to apply a generous amount of hot glue under the seam of the carpet. Slowly work your way all the way around the carpet until you have glued the carpet patch into place. (hint have a glass of water right next to you for when you get molten hot glue on your fingers. A quick dip will cool it off right away and prevent you from experiencing nearly as much pain.) When gluing the carpet patch down using the glue gun pay special attention to the backing. You want to glue the backing down so that its butted up just right. Also be especially careful to avoid getting the nap of the carpet pushed down into the hot glue. Its a mess when that happens and theres no recovery.
The next phase would involve the cleaning process itself. The removal of the resurfaced dirt will be done here. As mentioned there are different ways of cleaning the carpets but just so you know there are just three major cleaning procedures done when it comes to carpet cleaning. Carpet cleaning would involve hot water extraction dry extraction and cold water extraction. These methods usually work for a certain type of carpet cleaning job. It is best to research first on which is the suitable cleaning method to do so that cleaning will be done in the best way possible without leaving any dirt behind.