Martine Deblois Carpet June 18th, 2018 - 19:53:52
Removing replacing or installing new built-in furniture walls floor heaters toilets cabinets and other fixtures are just a few reasons that a carpet installer will need install the carpet properly into the room. This will require some new tack strip and possibly some new carpet and pad to add to the area. Many times the customer will have some carpet left over from the installation. If not we can often take carpet from the closet. Removing carpet and carpet pad is simple but sometimes strenuous. If we are trying to save the carpet to use in a different room or to re-carpet the hallway or stairway we will want to try to keep it in one piece. If the objective is just to remove old carpet and old carpet pad we will make it easy on ourselves by cutting the carpet into strips approximately two feet wide.
Most people are familiar with the fact that padding lies below the carpet which helps give it its comfortable feel when you walk on it. This is the bottom layer. Common types of padding include foam (cheap) rebond frothed foam slab rubber waffle rubber fiber (such as jute recycled textiles synthetic fibers etc.) and in some cases special Berber padding. Between the pile and the padding is the backing which is made of two layers and holds the fibers together so the carpet doesnt fall apart. When the carpet is manufactured needles are used to push the fiber through the primary backing. Its then sealed against the secondary backing with very strong adhesive to keep everything in place.
The following is an over-simplified tutorial. If you dont already know what youre doing then you will be better off just hiring a pro. If you decide that you want to tackle stretching your own carpet I suggest that you take your time use your head keep your blades sharp dont try to just kick it tight with a knee kicker and most of all be careful. The first step is to empty the room of furniture. If you really know what youre doing then you can probably work around some furniture but if youre a novice I suggest that you do yourself a favor and empty the room. Remove any metal strips that will be in the way. Some flat metal strips need to have nails removed. Another type of metal strip is called a clamp down metal. To free the carpet from the clamp down metal pry it open (just a little bit) with a flat chisel or a stair tool. There are too many different types of metal strips to describe here so youll just have to figure it out.
There are basically different phases that need to be completed when cleaning a carpet. Of course this is a very delicate thing in your household which needs to be cleaned properly. Without following these phases you are just risking the worsening of the condition of your carpets so you should always keep these in mind and you are on your way in maintaining the best conditions for your precious carpet. The first phase of carpet cleaning involves the pretreatment of your carpet. This may seem to be an unnecessary carpet cleaning step but in reality this is the most important cleaning step. This prepares and conditions your carpet so that it will be cleaned easily. What is done in this step is that the carpet is spayed or sprinkled with a particular solution that help in cleaning of the carpet. It basically lets the solid particles soils dirt and dust which are trapped inside the carpets to resurface and lift up. This will now make it easier for the particles to be cleaned.