Catherine Carpet July 01st, 2018 - 09:26:37
Removing the damaged carpet: Start by using a straight edge and a row finder. An ice pick or a Phillips screwdriver can be used instead of a row finder. Place the straight edge on the carpet with the groove side down. Use the row finder to separate the nap. Do this by dragging the point of the row finder across the carpet up and down and against the edge of the straight edge. Use a slotted blade knife with a fresh blade. You can use a slotted blade knife (butted up against the straight edge to cut through the carpet without cutting through too much of the nap if you used the row finder properly. The more nap you cut off the worse the carpet patch will look.
Cut the seam tape to the size of the carpet patch. Line up the carpet seam tape so that half of it is under the existing carpet and the other half of it will be under the patch. Use the glue gun to apply a generous amount of hot glue under the seam of the carpet. Slowly work your way all the way around the carpet until you have glued the carpet patch into place. (hint have a glass of water right next to you for when you get molten hot glue on your fingers. A quick dip will cool it off right away and prevent you from experiencing nearly as much pain.) When gluing the carpet patch down using the glue gun pay special attention to the backing. You want to glue the backing down so that its butted up just right. Also be especially careful to avoid getting the nap of the carpet pushed down into the hot glue. Its a mess when that happens and theres no recovery.
Carpet or slotted blade knife. Involved in almost every carpet repair task you can imagine a good carpet knife will never let you down. In the case of carpet stretching the knife is used to trim excess carpet from the edge after its been pulled tight. Staple gun. An industrial carpet staple gun isnt a regular staple gun. The staples are far narrower so that they fit between the nap. Carpet staple guns arent always necessary for carpet stretching but its good to have on hand just to make sure. Because a properly stretched carpet is pretty tight the tack strip alone may not hold it down satisfactorily in which case the staple gun eliminates any doubt.
The next phase would involve the cleaning process itself. The removal of the resurfaced dirt will be done here. As mentioned there are different ways of cleaning the carpets but just so you know there are just three major cleaning procedures done when it comes to carpet cleaning. Carpet cleaning would involve hot water extraction dry extraction and cold water extraction. These methods usually work for a certain type of carpet cleaning job. It is best to research first on which is the suitable cleaning method to do so that cleaning will be done in the best way possible without leaving any dirt behind.